PVC SOLVENT CEMENT

 

CHINLEAN® NO. 70 PVC Solvent Cement is clear colour, highly soluble fast-dry, high strength and stable quality, designed for all classes of uPVC pressure pipes and fittings from 15 mm to 100 mm diameters. When it is used in uPVC pipes it will instantly dissolve and blend with the pipe to produce a film of 0.4 mm thick, so that the fitting gap will be strong and stable.

 

APPLICATION
 
NO. 70 Solvent Cement is suitable on all types of uPVC pipe applications of use like potable water pressure systems, irrigation, conduit, industrial pipe applications, sewer, drain, waste and vent systems.
 
ADVANTAGES
  • Superior bonding strength
  • FastSetting
  • Waterproof Bonding
 
SPECIFICATIONS
Colour : Transparent
Resin : PVC
Density : Approx. 0.96 g/ml
Viscosity : 1,000 cps @ 23 ºC
 
STANDARDS AND CERTIFICATION LISTINGS
Standard ; MS628:Part2 : Section 2.2(equivalent to BS4346 Part3).
Certified by ; SIRIM QAS International Sdn. Bhd.
Certificate no. of : PC007118.
 
Listed in List of local building material / product from IRKAM QA Services Sdn. Bhd.
 
BRUSH SIZE
Up to 25mm : Ø8mm round brush
32 to 50mm : 1” flat brush
65 to 100mm : 2” flat brush
 
AVAILABILITY
NO. 70 PVC Solvent Cement is available in 500g weight metal cans. 20 cans per carton box (508mm x 220mm x 225mm)
 
SAFETY & FIRST AID DIRECTIONS
Avoid contact with eyes, skin and mouth. In case of contact with eyes, flush with water immediately for 15 minutes. Use in well ventilated area.
Keep out of reach of children
 
CAUTION
Do not decant or dilute, and the useful life of solvent cement can be conserved by replacing the lid or cap, as applicable immediately after each time of use.
 
DIRECTION FOR USE
  1. Cut pipe end square, remove all burrs.
  2. Mark the spigot with a marker at a distance equal to the internal depth of the socket
  3. Clean pipe end and inside of socket from dirt, grease, oil or water using clean cloth.
  4. Apply the solvent cement in full even coats to both surfaces, inside of socket and external of pipe.
  5. Push pipe firmly home to full depth of socket and hold the assembled joint for at least 30 seconds to allow initial bonding. The joint shall not be disturbed for at least 10 minutes after assembly. Eight hours drying time should be allowed before applying working pressure, and 24 hours before testing 1.5 times working pressure.